The AP7000 strain gauge load cells are installed in order to measure traction and/or compression strengths at one end of actuators, tie rods, ropes, junctions, hooks as well as for weighing, when they are installed under tank feet, silos and hoppers.
Compactness: The transducers of the AP7000 series are small, allowing them to be used in applications with little space available. High overload permissible: The innovative shear measurement principle makes it possible to accept high overloads (with static compression forces aligned along the axis of measurement and with tightening of the threads until the mechanical stop).
Environmental Protection: These transducers have been designed to be used in industrial environments where there is dust, dirt and moisture.
Internal Electronics: These load cells can integrate an optional analog or digital conditioning electronics (for measuring ranges from 10 up until 100 tons) that allows:
In addition to being able to integrate digital signals into the conditioning transducer, it is also possible to install amplifiers for the most common analog signals (voltage or current) thus obtaining a better signal/noise ratio.
|Sensibilità ponte estensimetrico|
|Effetto della temperatura sullo zero (entro 5°K)|
< ±0,1% FS
< ±0,15 % FS within 4 test hours at FS
|Ritorno a zero da pieno carico|
< ±0,07% FS after 30 min at FS
|Output signal type|
To make an order or to find the best solutions for your requirements, please don’t hesitate to contact us at the following email:[email protected]