Contact us: +39 02 89 101 42 – Contacts
0,00 €
Series HC/RC because of the bore hole are typically applied for automatic control of axial thrusts on punching machines, on machine tools, presses, power hammers, actuators and also to control the tension of steel cables in the civil engineering field.
Load cells series HC/RC have a large diameter central bore hole. The force must be equally shared on the top circular area around the central hole, while the reaction force is on another circular area too; It is mandatory to equally apply the force (usually by means of ball-joints) in order to recover mechanical misalignments (increasing accuracy and avoiding metal yeldings).
The transducers are well shielded against dirt by means of siliconic sealants and rubbers allowing an IP65 rating.
Load cells have a built in calibration circuitry. A calibration certificate is provided together with each unit.
Series HC/RC load cells can be connected to indicators and conditioners supplied by S2Tech:
Note: All the listed units, connected to the washers HC/RC, set up complete measuring systems
Fullscale | 1 Ton, 2 Ton, 5 Ton, 10 Ton, 20 Kg, 30 Ton, 50 Kg, 50 Ton, 100 Kg, 200 Kg, 300 Kg, 500 Kg |
---|---|
Total error | ≤±0,6% FS |
Sensitivity | 1 mV/V FS (typ) |
Temperature effect error on zero output | ≤±0,1% FS, within 5°K |
Creep | ≤±0,1% FS, within 4 hours at FS |
Return to zero from full load | ≤±0,1% FS, after 4 hours at FS |
Safe load limit | 50% max over FS* |
Ultimate load limit | 2 times FS* |
Material | Aluminium (Al) |
*The load must be applied on the weighing axis, uniformly distributed on the weighing and base surfaces. Thrust spherical plane bearings are advisable. For dynamic loads, with shocks and vibrations, difficult to estimate, the max load allowed has to be reduced to avoid yielding and ruptures.
To make an order or to find the best solutions for your requirements, please don’t hesitate to contact us at the following email:[email protected]